K-Tuned K-Swap Billet Shifter Base Plate Part Number: KTD-BIL-SHP

The K-Tuned Billet Shifter Base Plate is designed to install an RSX Type-S or comparable shifter box without cutting a hole in the exhaust tunnel of the chassis. 

• This setup is preferred by many racers, esp. road course racers, because it mounts the shifter higher in the vehicle, keeping it closer to the driver and the steering. 
• It also leaves a lot more room below the car for large exhaust systems
• The Shifter Base Plate was designed to route your shifter cables inside the car. 
• Generally users set them up to exit through the heater hose hole in the firewall. 
• Note that we assuming that the heater core has been deleted on most race cars. 
• We also want users to be aware that this shifter setup does not clear any interior panels or center consoles on any chassis. 

Due to the manufacturer’s price control policy, this item may be excluded from promotions and discounts

WARNING: This product may contain chemicals known to the State of California to cause cancer or birth defects. www.P65Warnings.ca.gov.